Fusion 360 Designs
This library contains .stp files for use in 3d cad programs like Fusion 360, though they should be compatible with most 3d cad design programs. Feel free to download, use, and modify as you want. In the case where there are aftermarket parts used in the design I will try and include the part numbers and manufacturers info.
Dual Brake Caliper assemly
Disclaimer: I have measured and re measured numerous times to ensure that the design is 100% accurate, but I have not had a chance to build and install these parts in real life, so I do not know if it will fit or work as designed. I plan to Have the bracket parts machined and tested with the other components by the end of 2015
|
Figure 1:
Figure 2:
|
This is the dual caliper brake setup for a Ford 9 inch axle. the parts I will build are the bracket parts that bolt to the flange and that the calipers also bolt to. The design uses the Big Ford (new style) axle housing flange (Figure 1) and a 2.5" axle off measured per Figure 2.
Wilwood Brake Parts in this design: - Forged Dynalite Caliper Part # 120-6806 - SRP Drilled Rotor, Iron, Black Electro Coat part # 160-7106-bk (left hand) - SRP Drilled Rotor, Iron, Black Electro Coat part # 160-7105-bk (Right hand) -Pro Street Hat, Standard, Aluminum Black E coat Part # 170-1827 Hardware parts # are embedded in the design as the component names. |
| ||
S10 2" Drop Spindle model
|
Here is the S10 spindle model from my pictometry scans. keep in mind this isn't 100% accurate, but is close. This model also represents my spindle which I cut off the original brake ears so it could accommodate the Wilwood brake kit.
|
| ||
Motorcycle Lift Stand
|
|
This is a motorcycle stand design I made. you can see my post about it here. It is designed to lift a dirt bike off the ground for work or storage. its a back saver. the .f3d file has a lot of components that are not seen as I didn't incorporate them in the actual stand or they didn't work out. feel free to download and used, change, or whatever.
|
| ||
